+- VDMIS USERS FORUM (https://www.vdmis.com/forum2)
+-- Forum: Forum Index (https://www.vdmis.com/forum2/forum-6.html)
+--- Forum: VDMIS Discussion Board (https://www.vdmis.com/forum2/forum-3.html)
+--- Thread: working with cad (/thread-23.html)
working with cad - DUNEDUNE - 02-25-2015
HI ,
New to 2014 r 1.5 and was wondering when writing a program why does one update the cad file that I am measuring to?
is it necessary to do so?? I am seeing this in older programs..
Thanks...
working with cad - jr6300 - 02-25-2015
you mean the non-DMIS command:
DMIS/OFF
UPDATE/CADMODEL
DMIS/ON
???
working with cad - jr6300 - 02-25-2015
Updating the cad model aligns the cad with your corrdinate system & measured features for visual references. You can also then take profile points directly on the cad off-line, then run on-line for true actual to cad profile.
You can also write the program off-line.
working with cad - DUNEDUNE - 03-10-2015
jr6300 Wrote:Updating the cad model aligns the cad with your corrdinate system & measured features for visual references. You can also then take profile points directly on the cad off-line, then run on-line for true actual to cad profile.
You can also write the program off-line.
thank you both....