Glad to see VDMIS is alive & well. Hopefully I'll be updating later this year. I had hoped to update last fall, but that fell through.
I'll look foward to hearing about 2014.
I have a demo off-line of VDMIS 2013 which I was using to preview before my hoped for upgrade & have some questions:
Does 2014 have the Program Mirror feature? It was never in the interface of VDMIS, but I used it a lot on symetrically opposite or handed parts. I didn't see in in my program folders in VDMIS 2013. Hopefully if it is gone I can still use my "old mirror & translators". I did a search on my VDMIS folder/directory & no "mirror" shows up. It used to be in the "VMSIges" folder that contained all the translators as well.
My monitor wasn't large enough to get the full display & I was @ my max resolution, so I couldn't see the entire toolbar.
I may have a few more questions a little later after I review my notes. One that comes to mind: Is "Cast" still in the Construction toolbar?
Can you still drag the Plane feature from the database onto the screen & it hi-lites in green even when I have Planes turned off in my Geometry (it gets messy showing planes all the time)? I a lot of times will drag the plane out onto my cad to make sure I'm am setting clearance, tolerancing or projecting to the correct plane & a visual says a lot.
I'll have a few more questions later.
Thanx in advance,
Joe
I'll look foward to hearing about 2014.
I have a demo off-line of VDMIS 2013 which I was using to preview before my hoped for upgrade & have some questions:
Does 2014 have the Program Mirror feature? It was never in the interface of VDMIS, but I used it a lot on symetrically opposite or handed parts. I didn't see in in my program folders in VDMIS 2013. Hopefully if it is gone I can still use my "old mirror & translators". I did a search on my VDMIS folder/directory & no "mirror" shows up. It used to be in the "VMSIges" folder that contained all the translators as well.
My monitor wasn't large enough to get the full display & I was @ my max resolution, so I couldn't see the entire toolbar.
I may have a few more questions a little later after I review my notes. One that comes to mind: Is "Cast" still in the Construction toolbar?
Can you still drag the Plane feature from the database onto the screen & it hi-lites in green even when I have Planes turned off in my Geometry (it gets messy showing planes all the time)? I a lot of times will drag the plane out onto my cad to make sure I'm am setting clearance, tolerancing or projecting to the correct plane & a visual says a lot.
I'll have a few more questions later.
Thanx in advance,
Joe