02-24-2015, 03:08 PM
jr6300 Wrote:Click on "Sensor" in upper toolbar (Probehead icon). Click on the far right hand icon for "Sensor Setting" (where you set your Approach & Retract). Drag (or type in) the plane into the bottom window & set the Clrsrf right above this window to your desired clearance & click Apply.
One note: Make sure that if your plane is a contructed plane out of points that the X, Y or Z vector is reading correctly or it will try to "clear through the surface" to the other side. Normally if it is a plane taken as a feature it will have the correct vectors. (X,Y,Z = I,J,K vectors respectively in Window or Code)
Hope this helps.
Thank You Very much for the reply. Are you talking abour the same clrf where I have been inputing the approach and retract distance for the probe. I always thought it was the clearence for the probe only. This should take care of my problem. one more thing before I close. when you have the learn on in Program would just turning the learn off put a DCC off statement in the program. Thanks again.